十個手把手的有趣Micro:bit 實驗

Experiment One: Say 'Hello' to the BBC micro:bit.
Experiment Two: Using an LDR(Light Dependent Resistors) & analog inputs.
Experiment Three: Dimming an LED using a potentiometer.
Experiment Four: Using a transistor to drive a motor.
Experiment Five: Using the accelerometer to control motor speed.
Experiment Six: Setting the tone with a piezo buzzer.
Experiment Seven: Wind power.
Experiment Eight: Making a game using the compass.
Experiment Nine: Capacitor charge circuit.
Experiment Ten: Using an RGB LED.

課程材料清單

須使用Micro:bit Edge Connector 連接到麵包板且須準備下列材料才能製作

1 x Perspex Mounting Plate.
1 x Potentiometer & Finger Adjust Spindle.
2 x Plastic Spacer 10mm.
1 x Sticky Fixer for Battery Pack.
1 x Small Prototype Breadboard.
1 x Terminal Connector.
4 x Push Switch.
1 x Motor.
1 x Transistor.
2 x Red 5mm LED.
2 x Orange 5mm LED.
2 x Yellow 5mm LED.
2 x Green 5mm LED.
1 x RGB 5mm LED.
1 x Fan Blade.
5 x 2.2KΩ Resistor.
5 x 10KΩ Resistor.
5 x 47Ω Resistor.
1 x Edge Connector Breakout Board for BBC micro:bit.
1 x Miniature LDR.
10 x Male to Male Jumper Wires.
10 x Male to Female Jumper Wires.
4 x Self-adhesive Rubber Feet.
1 x 470uF Electrolytic Capacitor.
1 x Piezo Element Buzzer.
4 x Pan Head M3 Machine Screw.